QC Inspector

Policies & Procedures-▪ Comply with operational procedures and instructions when
performing all job tasks and activities

In-process inspection - ▪ Ensure only approved and QC accepted raw materials are
used in the manufacturing process
▪ Ensure that the production process comply with the technical
Know-How documents & Quality Assurance Procedures
▪ Conduct the refractive index check of the epoxy
resin/hardener mix ratio to ensure it meets the set requirements
▪ Check and monitor the ambient temperature and humidity
▪ Witness the production processes and ensure that the
relevant approved Raw Material Calculation and Machine Set ups are followed to meet the project requirements
▪ Inform the non-conformances immediately to the responsible Machine Captains and other employees in the Production and QC departments so corrective actions can be taken

Online / Offline Inspection of Pipes and Couplers - Inspect the pipes and couplers as per the requirements of the product drawing, following the inspection and testing program. Select QC samples during the production process as per the inspection program and/or project ITPs as applicable.

Trading materials inspection ▪ Inspect the products purchased from the other manufacturing units or sub supplier and ensure that those products meet the project specification requirements and release them for delivery. ▪ Inspect the locking strips, different types of gaskets such as Kroll and Ziller, O-rings, flat gaskets in order to ensure the quality meets the minimum specified requirements

Non-destructive testing - Conduct the non-destructive tests as per the ITP requirement
▪ Witness the routine hydro tests for the Pipes and Couplers

Destructive Testing - ▪ Conduct the non-destructive tests as per the ITP requirement
▪ Witness the routine hydro tests for the Pipes and Couplers

Destructive Testing - ▪ Conduct the destructive tests in accordance to the ITP
requirements and project commitments agreed with the Client/consultant
▪ Witness and monitor the short term and medium term survival tests periodically and ensure the tests are not affected with any climatic effects and successfully completed as per the project requirements

Preparation of reports, TPI inspection and release - ▪ Prepare the daily QC internal reports as well as project specific documentation (Manufacturing Record Book - MRB) to be submitted to the Client
▪ Carry out the final inspection and release together with the Customer TPIs and Client TPIs for all the products comes under the major projects based on the project-specific requirements. Also perform additional tests as per the ITP for the witness point of Customer/Client

Stock counting - ▪ Participate and lead a small team of employees during the Half- yearly and Yearly stock counts to ensure that the physical inventory matches the ERP system inventory
▪ Carry out monthly stock counting for the major raw materials in the store's warehouse and provide the actual data to the QC Engineer for monthly RM stock count report

Mould & Socket Sleeve inspection - Carry out steel, mould and socket sleeve inspection either at factor of at suppliers permises as per the relevant.engineering drawings to ensure that those moulds are manufactured as per the given approved drawings

HSE - ▪ Comply with relevant safety, quality and environmental
control procedures and instructions
▪ Use personal protective equipment and safety gear when
performing assigned tasks
▪ Keep operational areas clean and well-organised to prevent
incidents and accidents
▪ Report unsafe acts, incidents or safety violations
▪ Develop a safety culture by ensuring all staff comply with
HSE policies and procedures
▪ Participate in QHSE audits, incident reporting and review of
QHSE performances as required